Achieved Results

Succesful prototyping of 1Ah cells with integrated level 2 sensors

29 March 2023 – SENSIBAT partners were able to demonstrate the successful integration of Level 2 sensors in 1Ah cells. The prepared cells were electrochemically investigated, providing the project partners…

Characterization of 3-5 cm2 pouch cells with integrated level-2 sensor

27 Feb. 2023 – The report on “Characterization of 3-5 cm2 pouch cells with integrated level-2 sensor” describes the activities related to the characterization of the Li-ion battery pouch cells…

Integrated novel level 1 sensors into 5Ah pouch cells

20 Dec. 2022 – The overall goal of SENSIBAT is to manufacture two demonstrator battery packs with a novel battery management system (BMS) and Li-ion pouch cells with integrated sensor…

Rapid prototyping BMS Master

30 November 2022 – IKERLAN has developed a novel BMS-Master compatible with the advanced BMS slaves and the cell-integrated SENSIBAT temperature and pressure sensor. The developed BMS-master hardware board is…

Prototype circuit to read-out a cell-integrated 5×7 temperature and pressure sensor matrix

30 Sept. 2022 – In order to measure the temperature and pressure distribution over the electrode area of a Li-ion pouch cell, a sensor matrix was developed. This sensor matrix…

Development pouch cell assembly included printed reference electrode

1 June 2022 – The integration of reference electrodes into Li-ion battery cell is envisioned as a potential tool to unlock novel sensing functionalities into current Battery Management Systems (BMS),…

Report on the development of printed electrodes on cell components

5 May. 2022 – This report is a summary of the activities on development of printed electrodes on cell components and and evaluation of their performance. The main objective was…

Progress report on SENSIBAT’s Cell Integration of sensors

26 Oct. 2021 – Within the past months the SENSIBAT partners produced and benchmarked 1Ah and 5Ah baseline cells. The electrochemical performance of these cells was estimated to provide a…

Update on the design and development of electrodes

22 Oct. 2021 – Bedimensional S.p.A. and Politecnico of Turin are designing and developing reference electrodes for electrochemical sensing in Li-ion batteries in the framework of the SENSIBAT project. These…

Dissemination and exploitation plan

30 Mar. 2021 – The SENSIBAT project is going to maximise the dissemination of the achieved research results and to make the results understandable to researchers who are not directly…

Testing plan for cells and modules

23 Mar. 2021 – The tests defined in this report, first, shall enable an in-depth evaluation of the influence of the integrated sensors on the operational parameters of the cell….

Use Cases, KPI’s and Cell, Module Requirements

16 Feb. 2021 – The requirement specification document lays out the requirements for the cell-integrated sensors (2D temperature and pressure sensors as well as auxiliary electrodes), the read-out electronics, the…

Report on selection of inks and pastes

26 Feb. 2021 – The deliverable D.2.1 “Report on selection of inks and pastes” summarises the activities and results related to the realisation of novel sensing technology based on printed…

Project Handbook

21 Dec. 2020 – The Handbook contains an overview of management bodies and information about the project needed in the day-to-day project practise. The document is based on Annex I…

Project Identity

2 Dec. 2020 – Effective dissemination and communication are important to ensure adoption of the SENSIBAT technologies during and after the project. This deliverable describes the SENSIBAT project identity which…

Project Flyer

1 Oct. 2020 – The project flyer has been published! You can find the web version below. If you are interested in printing the flyer for further distribution during events,…